 |
1997, 440 volt Electrover 650 Wave with lots of options, good shape, refurbished in 2004 and very little use since. - 3 module bottom Vectra Convection Heat - 2 top IR Preheaters - Foam fluxing - Lamda wave with turbulent option - Spinning turbulent Chip wave - Special wide conveyor width option - Finger cleaner - Filled with 63/37 Lead solder in good condition |
 |
Electrovert Econopak II 16
Listed on 10/15/10
in our inventory
16 inch computer controlled machine. Finger conveyor with finger cleaner, foam fluxer, 2 lower and 1 upper preheatrers, roll out solder pot with Lamda and Omega waves and nitrogen. New in 1988, 220 volt, 3 phase, 39.9 amps. S/N MO8811118001
|
| |
Electrovert Econopak Plus 1999 converted to LEAD FREE
- N2 Machine
- External fluxing cabinet
- USI Ultrasonic reciprocating spray fluxer
- Extended rails
- Finger conveyor
- Qty of three Vecta heat forced convection Pre-heaters
- Dual wave system
- Dual Convection Pre-heaters
- Topsice IR Preheater
- Contour N2 wave
- Rotary N2 chip wave
- Auto width adjust
- Cast Iron pot
- Motorized roll out solder pot w/ jacking stand
- Computer controlled
- All nozzles and pumps coated with Melonite Coating
|
| |
Electrovert Econopak Plus 1999 converted to LEAD FREE
- Vintage October 1999
- Left to Right operation
- Internal Spray Fluxer
- 2 Bottom convection Pre heaters
- IR top Preheat
- Dual Wave with Rotary Chip wave
- Contour Lambda wave
- DCast Iron Solder pot no coating needed
- Air knife for flux only
- Manual Jack stand
- Hand crank and adjust
- V fingers currently, L fingers added on request no extra charge
- 480V 3 Phase
|
 |
Listed 3-08
- EPK+ Wave Solder Syetem
- 1998 Vintage
- USI spray Fluxer - Optiflux
- 2 convection preheaters?
Nitrogen
- Contour nozzle?
Rotary chip wave?
Motorized with adjustment, jacking stand and rollout?
Titanium liner for solder pot
- Titanium flow ducts, nozzles, and pumps?
Ready for lead-free soldering
- Tool is wrapped and Stored
?
|
Soldering